A big printer part 1

Does not say it in instructions, but........

....."rearrange 3d printer room until you have a place where the new printer will fit" was part of my setup routine.

So was getting rid of the packaging.  This white stuff is non-recyclable. :-( .

Assembled.

Smoko during Assembly.

More Assembly.....

And yet more.

After threading the filament through and doing some levelling it is all go, this was the successful test print.

Hi

For a while now, I have been reading and writing about Delta 3d printers and had seen some low prices for the Anycubic Kossel.  By the time I got round to actually buying one, the Kossel seemed to be out of stock or obsolete, replaced by the 4wd-truck-sounding "Predator".  At about $530.00 the Predator was just a bit more expensive than the Cetus printer I already own.  But the Anycubic is much bigger.  Anyway, videos like this one spoke highly of the printer, and now I have one!Will report further later.